If your VoIP phone is displaying "No Service", it means the phone cannot register with the server. This is typically a network or configuration issue. VoIP handsets are sensitive to even brief connectivity drops, so a short interruption you didn't notice can still cause "No Service". Follow the steps below to identify and resolve the problem.
1. Check your network connection
Make sure the Ethernet cable is securely connected to a LAN port on your router, not the WAN port.
Try a different LAN port on the router.
Try a different Ethernet cable.
Verify your internet is active by browsing a website on another device connected to the same network.
Run a speed test on another device, and a ping test if you can, to check your connection is stable enough for VoIP.
If your phone is on Wi-Fi, connect it with an Ethernet cable instead.
Place your router in an open, central spot, away from thick walls and other electronics.
If your mobile app works but your desk phone does not, it may indicate a network or router issue rather than an account problem, as mobile apps use different network pathways such as push services.
Disconnect and reconnect the Ethernet cable to ensure a proper connection.
2. Power cycle your equipment
Turn off your VoIP phone.
Turn off your router.
Wait 2 minutes.
Turn the router back on first and wait for it to fully connect.
Turn the VoIP phone back on and wait for it to register.
If it still shows "No Service", try the phone on a different router, if you have one, to rule out a router hardware fault.
3. Check the phone is registered
Check the phone screen for a registration status or extension number. If the phone is not showing your extension, the account may not be registered on the handset. See Account registered on handset.
If the phone displays 'autoprov' mode, it means the handset is in auto-provisioning mode and attempting to configure itself using server settings. To resolve this, access the phone's web interface, navigate to Settings > Auto Provisioning, and follow the prompts to complete the process.
4. Check your account status
Log in to the MybOnline portal and check that your account is active. If your account has been suspended due to an outstanding balance, your phones will show "No Service". See Why is my account suspended?
5. Check for multiple phones on the same network
If you have more than one VoIP phone on the same network and only some are showing "No Service", check that each phone has a unique IP address. IP address conflicts can prevent phones from registering. See How to find the IP address of your Yealink device?
6. Check your device is compatible
A handset that isn't supported may not register, even when your network and account are fine. Check your phone is on the list in List of compatible devices for bOnline phone. If you're setting up a Yealink phone, see How can I set up Yealink phones with bOnline, and are other phones compatible?
7. Check router settings
Certain router settings can prevent phones from registering:
SIP ALG: if SIP ALG is enabled on your router, it can block the phone from registering with the server. See Understanding SIP and ALG settings for VoIP phone systems.
Firewall: your router's firewall may be blocking SIP traffic on ports 5060 and 5061. Check that these ports are not restricted.
Quality of Service (QoS): if your router supports QoS, configure it to prioritise VoIP traffic. This helps maintain call quality and registration stability on congested networks.
Firmware: regularly update your router firmware to maintain compatibility with VoIP services.
8. Factory reset as a last resort
If none of the above steps resolve the issue, a factory reset will restore the phone to its default settings. After a reset, the phone will need to be re-provisioned using the correct details from your bOnline portal. See How to factory reset Yealink phones.
If the issue continues after following all of the above steps, contact the bOnline support team through live chat. If persistent issues occur, contact your ISP as they may need to adjust network settings for VoIP compatibility before reaching out to bOnline support.
